Product Description
LS INSTALL KIT
Our LS install kit allows the installation of standard 1/8-27NPT threaded senders to be installed in the standard LS ports. M12 bushing allows the use of full-length temperature senders, no need for a special "short" sending unit. Also included is a pre-wired step-up resistor for tachometers reading a tach signal from the PCM.
Bushings are made by hand here in Detroit from US made Brass hex stock. Each part is fixture checked for accuracy and fitment.
NOTE: DOES NOT FIT GM LT (GEN 2) ENGINES. The LT requires an M-12 x 1.75" thread, we are not sure why they changed the thread pitch, but GM decided to for some reason!
KIT CONTENTS
1EA M16X1.5(M) TO 1/8-27 NPT( F) W/ GASKET
1 EA M12X1(M) TO 1/8-27 NPT (F) W/GASKET
1 EA 10K OHM RESISTOR
Warranty Information
Reviews
-
did just needed for LS3 engine temp
Fast shipping
-
did just needed for LS3 engine temp
Fast shipping
-
M12x1.5 to 1/8 NPT
Worked fine. Be sure not to over tighten.