HOW TO IDENTIFY THE GAUGE YOU HAVE
We are always innovating here at NVU by upgrading platforms as technology changes. Over the past 20 years we have had several iterations of instruments to suit a wide range of needs. Please see below for each type.
PHOENIX DIRECT DRIVE MAIN DRIVERS-SPEEDO AND TACH
12-pin AMP connector, WITH external ports, WITH OLED SCREEN
INSTRUCTIONS PHOENIX BIG BOOK HERE>>>
PHOENIX DIRECT DRIVE MINOR GAUGES- FUEL, TEMP, OIL, VOLT
6-pin plugs with harnesses plug into speedo and tach. NOTE: BULB SOCKET NOT USED INTEGRATED LIGHTING.
INSTRUCTIONS PHOENIX BIG BOOK HERE>>>
PHOENIX GAUGES SPEEDO, TACH, 3-1, SPEEDO/TACH QUAD, DUAL GAUGES --NOT DIRECT DRIVE
12-pin AMP connector, NO external ports, with OLED SCREEN
INSTRUCTIONS PHOENIX BIG BOOK HERE>>>
PHOENIX TACHOMETER WITHOUT OLED SCREEN
12-pin AMP plug, DIP switches under black cover to change cylinder selection. NO OLED SCREEN
2017-UP DOUBLE SHIELDED AIRCORE
Short sweep, coated metal case, BA9 bulb/socket with leads, metal back clamp. Small studded connections.
The instruction manual for this setup is HERE
A90 (ANALOG 90) 2-1/16" GAUGES
White plastic case, DIP switches, 4 and 3 pin ports. NOTE: BULB SOCKETS NOT USED, INTEGRATED LIGHTING
THE ITEMS BELOW WENT OUT OF PRODUCTION END OF 2017 WITH THE LAUNCH OF THE PHOENIX PLATFORM
SPEEDOMETER WITH 4 AND 6 PIN CONNECTOR.
Identified by the 4 and 6 pin connector on the back and LCD screen on the front.
The instruction manual for this setup is HERE
STUDDED SPEEDOMETER
Identified by the studded connections on the back. IGN, GND, SIG and button. This uses the 3-1 type programming and the instruction booklet is HERE
STUDDED TACHOMETER
Identified by the studs to make connection on the back. There is a label with a selector on the back as well.
This tachometer type does not have a screen, display or indicators in it.
3-1s and SPEEDO/TACHS PRE-2017
Identified by the 2 6-pin connectors on the back.
The speedo/tach has an offset from the center speedometer pointer.
This uses the 3-1 type programming and the instruction booklet is HERE
"OLD STYLE" AIRCORE
Plastic case short sweep. Studded connections, 194 twist lock bulb/holder.
The instruction manual for this setup is HERE
GEN II STEPPER MOTOR GAUGES SPEEDO AND TACH
Plastic case with spin-on back clamp (3-3/8") 4-3/8" has bolt-on back clamp.
8-pin amp connector, flat pointer hub
The instruction manual for this setup is HERE
GEN II STEPPER MOTOR GAUGES 2-1/16"
Plastic case with spin-on back clamp
8-pin amp connector, flat pointer hub small studs for connections.
The instruction manual for this setup is HERE
